| The Safrane.Info Forum! http://safrane.info/forum/ |
|
| alloys for a safrane? http://safrane.info/forum/viewtopic.php?f=3&t=421 |
Page 1 of 1 |
| Author: | placidcasual [ Wed Jun 10, 2015 1:13 pm ] |
| Post subject: | alloys for a safrane? |
Quick question, i'll be honest i'm not too clued up on alloy wheel fitments.. Mine are 4 the original phase 1 safrane 4 stud but are really badly flaked and i'd quite fancy a change. Will any renault 4 studs fit relatively ok without any handling issues or do i need to be more specific? Or would any aftermarket 4 stud alloy fit ok? Can anyone recommend something that looks good as well, especially on a safrane? |
|
| Author: | SAFRANEV6RXE [ Thu Jun 11, 2015 11:33 am ] |
| Post subject: | Re: alloys for a safrane? |
This is a very difficult one as most Safranes are 5 stud,i THINK laguna wheels are the same PCD but not 100% sure and again alot are 5 stud,its going to be abit difficult to find a set you want i think. |
|
| Author: | placidcasual [ Wed Jun 17, 2015 9:17 am ] |
| Post subject: | Re: alloys for a safrane? |
thanks, i'm not sure how much the PCD absoutley needs to match up with original specs or wether there is a little give or take or not. I'm seeing plenty 4 stad laguna wheels on ebay but ideally i'd prefer something a little nicer looking than laguna wheels! |
|
| Author: | Saffles [ Mon Jun 22, 2015 12:47 am ] |
| Post subject: | Re: alloys for a safrane? |
It's an R reg.. also got no electric front seats indicating that it's pov spec.. even though they were only 2L normally... but this is 2.5.. but it has a strange looking fuel cap - probably from a volvo. If i had the time, money and enthusiasm i'd have it. I'm after a black one and i have the spare leccy seats but i can't be doing with two safranes. I'm working on the current one now trying to get it sorted out to go back on the road again. |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|